After you’ve eaten through your food storage, you’re left with a number of empty cans. Now what? We collect a few ideas on what to do with that #10 can.
With a simple can opener and candles, you can create an effective lantern. Be sure to wash out the can first. You can use the pointed edge of the can opener to puncture holes in the sides of the can. Place the candle inside the can and it becomes a lantern with direction-light. You can also add handles or sidebars to take the light on the go.
Some people have even used a small nail to create designs on the sides of their lanterns
This advice comes from CountryLiving.com.
Four 6-inch-length wire-core wicks, primed
4 wick holders
4 tin cans, approximately 4 inches deep and 2 inches wide
2.5 ounces stearin
1 disk wax dye, if desired
1.5 pounds paraffin wax
1. Insert a length of primed wick into each wick holder and place a wick in the center of each tin.
2. In the top of a double boiler over medium heat, melt the stearin and wax dye, if using.
3. Add the wax. Melt and mix thoroughly. Heat to 190 degrees Fahrenheit.
4. Anchor the wicks in the tins by pouring enough wax into each tin to cover about 1/2 inch of each wick. Allow the wax to cool for about 30 minutes.
5. Wrap the end of the wicks around tie rods and rest the rods on the tops of the containers. Take up any slack in the wicks and center them within the tins. Be careful not to dislodge the anchors.
6. Reheat the wax to 190 degrees Fahrenheit and fill the tins to within 1/2 inch of the top. Allow to cool for one hour.
7. If the wax settles, reheat the remaining wax to 190 degrees Fahrenheit and top off the candles as necessary.
8. Cool for several hours or overnight. Remove the tie rods, trim the wicks to 1/4 inch, and the candles are ready to light.
DesignSponge.com has a great tutorial on how to create a pincushion out of a smaller can - like a tuna or cat food can.
1 Small tin can
1 Piece of fabric, approx. 8” x 8”
Handful of poly-fil
Small piece of gift wrap or other decorative paper
Blade and straight edge for cutting paper
1. Carefully remove label from outside of can.
2. Trace label onto your piece of decorative paper, adding 1/2″ to the length for overlap.
3. Attach to can with one small strip of double-stick tape, and overlap ends with a second piece of tape.
4. Place a handful of poly-fil in the center of your fabric square, gathering the ends to create a loose ball shape.
5. Line the inside rim of the can with hot glue and insert the fabric/poly-fil ball, with raw edges going into the bottom of the can.
6. Tuck in fabric until it is taut. insert pins.
Be sure to read our part 2 of "What to do with a leftover #10 can."